Hi @dxMeta
there is no ‘reset’ or anything similar; but here are a few steps you can perform to get it connected again:
- I assume the camera is correctly powered, either by DC or PoE
- first of all you should check if the lights on the Ethernet port of the camera light up. If you are using a Harting cable (which hides the LEDs) you should switch to an RJ45 cable for this.
- the N35 models need the uEye driver installed, which I suppose you did, as you wrote.
- next you should rule out a configuration issue on the host PC. The simplest way would be to manually launch the Network Wizard from NxView an select ‘N35’ in the first dialog. This will make NxView check and fix all kinds of configurations for the uEye driver and the respective ethernet port
If the camera is not ‘dead’ (e.g. not LEDs lit), these steps should make it appear in the camera list again.
Let me know if this helps.